Enabling LiteMage Administrative Privilege Browser Commands

There are three methods of enabling LiteMage administrative privilege browser commands for your Magento site. The one you choose to use will depend on the mode you would like LiteMage to be in at the time as well as the type of commands you would like access to.

The following are two methods of enabling debug-related browser commands on your Magento site.

All debug-related commands will contain “LITEMAGE_DEBUG”.

By putting LiteMage in debug mode you are giving any IP that can access your site permission to use debug-related browser commands with regard to LiteMage. It is not recommended to do this unless your Magento site is only accessible by you at the time.

To enable Debug Mode, log in to the Magento Admin Panel and navigate to System → Configuration. Under “LITEMAGE CACHE” in the left side menu, click “LiteMage Configuration”. Under “Developer Testing” set Enable Debug to “Yes”.

By enabling LiteMage for certain IPs only, you are giving permission to use debug-related browser commands with regard to LiteMage to those specific IPs as well as disabling LiteMage for all other traffic to your site. This setting can be very useful for debugging.

To enable LiteMage for certain IPs only, log in to the Magento Admin Panel and navigate to System → Configuration. In the left hand side menu under “LITEMAGE CACHE”, click “LiteMage Configuration”. Under “Developer Testing” add the desired IPs to the Enable LiteMage Cache Only for Listed IPs field.

The following method will enable all available browser commands (including debug-related browswer commands).

This is the most direct and least obtrusive way of enabling administrative privilege browser commands for specific IPs. This can be less useful for debugging, as LiteMage will remain enabled for all visitors to your site.

To add your IP to the Admin IPs list, log in to the Magento Admin Panel and navigate to System → Configuration. In the left hand side menu under “LITEMAGE CACHE”, click “LiteMage Configuration”. Under “General Settings” add the desired IPs to the Admin IPs field.